110C96562500 Kenmore Dryer Parts List

Leveling leg locking nut (locking nut for leveling leg)

This nut is sold individually. Size: 3/8-16

Washer (support washer)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Blower housing seal (seal, blower cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring for idler pulley arm in dryer)

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Seal, outlet housing (outlet housing seal with adhesive strip)

Thermal cut-off (thermal cutoff)

The thermal cut off fuse will disrupt the power flow to the drive motor when the dryer gets too hot. If your dryer will not heat properly, or will not heat at all the issue could be with a faulty or damaged thermal cut off fuse. Before you replace the faulty cut off fuse, make sure you disconnect the power from your dryer.

Stacking kit

This kit allows you to stack your washer and dryer to maximize your laundry space.

Clamp-motor (motor retaining clamp)

This clamp is used to secure the drive motor.

Side and bottom vent kit (side or bottom venting kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Electronic control board (main control board. Note: This part is often misdiagnosed. Please enter your dryer model# in our repair help section for additonal repair help.)

This part is located in the control panel. It senses the resistance change and opens and closes a relay sending power to the dryer heater.

Door switch with wire (dryer door switch & harness assembly)

This part is what tells the dryer to stop running when the door is open.

Natural gas limiter (gas valve leak limiter, natural gas. *do not adjust factory set nozzle under the limiter.)

Moisture sensor wire harness (harness, sensor)

Lens (light lens cover)

This parts covers the bulb inside the drum.