11014852300 Kenmore Washer Parts List

Inlet hose - 5 ft (hose, water inlet (2) (blue coupler))

This hose can handle hot or cold water and is five feet long.

Washer gear case cover seal (seal, gearcase cover)

This part prevents the agitator shaft from leaking oil onto the transmission.

Single motor grommet (grommet, motor (4))

Sold Individually.

Oil seal kit for gearcase input shaft (seal, thrust plug)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Screw (screw & washer, lid switch)

Sold individually.

Water level switch (switch, water level)

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

Capacitor, motor start

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Neutral drain kit (neutral assembly)

Water inlet hose washer (washer, water inlet hose (4) (1-1/16 x 5/8))

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Screw, console (screw, 8-18 x 1.25 (console to top))

Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus. 13, 14 & 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Seal-shaft (seal, oil)

Transmission shaft seal.

Agitator cam bearing (bearing-driven cam)

Knob spring-clip (knob, clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.