11016852500 Kenmore Washer Parts List

Inlet hose - 5 ft (inlet hose)

This hose can handle hot or cold water and is five feet long.

Console clip

Sold individually.

Washer gear case cover seal (gear case cover seal)

This part prevents the agitator shaft from leaking oil onto the transmission.

Single motor grommet (motor grommet)

Sold Individually.

Oil seal kit for gearcase input shaft (seal)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Neutral drain kit (neutrl pak)

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Counter balance spring kit (spring)

This kit includes 3 springs.

Agitator repair kit (agitator cam repair kit)

Washer, agitator (washer)

Sold individually.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor (motor switch)

Rear leveling foot (foot)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.