11016972500 Kenmore Washer Parts List

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Counter balance spring kit (spring)

This kit includes 3 springs.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Rear leveling foot (foot)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Gearcase oil (gear case oil)

This gearcase oil comes in a 16 Oz bottle.

Shaft, agitator (complete) (shaft)

This kit is used for direct drive washing machines and is found inside the gearcase.

Water inlet and dispenser valve (valve)

Ring-wire (ring)

This is part of the Basket Drive and found under the Brake Lining parts.

Cord-power (power cord)

Water pressure hose - cut-to-fit (hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support (ring)

Used with clutch.

Brake shoe assembly (brake shoe)

This assembly comes with two brake shoes.

Motor start capacitor (start capacitor)

This capacitor gets the motor up to speed before transferring power to the run capacitor.

Lid switch

This purpose of this part is for the tub to stop spinning when the washer lid is opened. The washing will resume when the lid closes.