11020022010 Kenmore Washer Parts List

Drive block - 2 5/16 inch high (block-driv)

This part is for large capacity belt drive and direct drive appliances.

Washer

This part goes on the agitator retaining bolt.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Hose clamp (clamp, hose)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Drain pump - 120v 60hz (water pump)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time

Spanner nut

Right hand threaded nut holds the tub in place in direct drive, top loading washing machines. To remove the spanner nut you will need a spanner wrench.

Console clip

Sold individually.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Seal-tub (tub seal)

Agitator cam bearing (bearing)

Upper agitator (top half of agitator assembly)

Washer drain hose (hose)

The drain hose carries used water from the washer to your house drain.

Leveling leg (leveling feet)

Sold individually.

Shield

Washplate bolt (screw)

Sold individually.