11020272000 Kenmore Washer Parts List

Screw, console

Sold individually.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Rear leveling foot (foot)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Switch, main drive motor (motor switch)

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Gearcase oil (gear case oil)

This gearcase oil comes in a 16 Oz bottle.

Nut-push-in (nut)

Sold individually.

Balance ring - top of inner tub - white (balance ring)

Control panel hinge (hinge panel)

Sold individually.

Water pressure hose - cut-to-fit (hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support (ring)

Used with clutch.

Bracket, spring outer (l.F.) (bracket)

Touch-up paint - almond (tuchup)