11020402990 Kenmore Washer Parts List

Knob spring-clip (spring clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Lid switch actuator assembly (actuator)

This part is used to activate the lid switch when the lid opens/closes.

Rear leveling foot (foot)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor (motor switch)

Gearcase oil (gear case oil)

This gearcase oil comes in a 16 Oz bottle.

Nut-push-in (nut)

Sold individually.

Control panel hinge (hinge panel)

Sold individually.

Cord-power (power cord)

Water pressure hose - cut-to-fit (hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support (ring)

Used with clutch.

Bracket, spring outer (l.F.) (bracket)

Touch-up paint - almond (tuchup)