11020932994 Kenmore Washer Parts List

Centerpost bearing and seal assembly (centerpost bearings and seals)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust (washer)

Fits under the basket drive assembly.

Inner tub filter plug kit (filter plug4)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Washer, agitator (washer)

Sold individually.

Rear leveling foot (foot)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Switch, main drive motor (motor switch)

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Gearcase oil (gear case oil)

This gearcase oil comes in a 16 Oz bottle.

Nut-push-in (nut)

Sold individually.

Cord-power (power cord)

Water pressure hose - cut-to-fit (hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support (ring)

Used with clutch.

Bracket, spring outer (l.F.) (bracket)

Motor start capacitor (start capacitor)

This capacitor gets the motor up to speed before transferring power to the run capacitor.

Lid switch

This purpose of this part is for the tub to stop spinning when the washer lid is opened. The washing will resume when the lid closes.