11020936990 Kenmore Washer Parts List

Screw, console (screw)

Sold individually.

Knob spring-clip (knob, clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus. 13, 14 and 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Inner tub filter plug kit (plate, filter)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Washer, agitator

Sold individually.

Rear leveling foot (foot, rear (2))

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Gearcase oil (oil, gearcase (16 oz.))

This gearcase oil comes in a 16 Oz bottle.

Nut-push-in (nut, push-in)

Sold individually.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Control panel hinge (hinge, console (2))

Sold individually.

Cord-power (cord, power)

Water pressure hose - cut-to-fit (hose, pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.