11021102012 Kenmore Washer Parts List

Lid hinge bearing (bearing, lid hinge)

This is the bearing for the lid hinge. Sold individually.

Drive block - 2 5/16 inch high (block-driv)

This part is for large capacity belt drive and direct drive appliances.

Washer

This part goes on the agitator retaining bolt.

Lid latch strike (strike)

This part is the replacement lid latch or latch assembly for your top-load washer. The lid latch holds your washer door closed, and allows the washer to run its cycle. If the lid latch is damaged, your washer door may not close properly and you may not be able to run your washer. The latch is found under the lid and can be screwed out and replaced. You will need a Phillips-head screwdriver for this repair. This part is sold individually and is and OEM part from the manufacturer.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Hose clamp (clamp, hose)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Drain pump - 120v 60hz (water pump)

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time

Spanner nut

Right hand threaded nut holds the tub in place in direct drive, top loading washing machines. To remove the spanner nut you will need a spanner wrench.

Leveling leg locking nut (nut)

This nut is sold individually. Size: 3/8-16

Console clip

Sold individually.

Seal-tub (tub seal)

Agitator cam bearing (bearing)

Upper agitator (top half of agitator assembly)

Washer drain hose (hose)

The drain hose carries used water from the washer to your house drain.

Leveling leg (leveling feet)

Sold individually.