11022992103 Kenmore Washer Parts List

Leveling leg locking nut (nut, 3/8-16)

This nut is sold individually. Size: 3/8-16

Lid hinge pad (pad, hinge)

Sold individually.

Spacer (spacer, cabinet to top)

Used to put a space between the cabinet and the top of the washer.

Inlet hose - 5 ft (hose, water inlet - blue coupler)

This hose can handle hot or cold water and is five feet long.

Cabinet retaining clip (clip, top and cabinet and rear panel (2))

CLIP-TOP&CAB-R PNL

Clutch assembly (clutch - complete)

Used with large capacity, automatic washers.

Single motor grommet (grommet, motor (4))

Sold Individually.

Water level switch (switch, water level)

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Screw, console (screw)

Sold individually.

Knob spring-clip (clip, knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus. 13, 14 and 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Counter balance spring kit (spring, counterweight)

This kit includes 3 springs.

Washer, spin tube thrust

Fits under the basket drive assembly.

Touch-up paint - biscuit (paint, touch-up (1/2 oz.) bisque)