11024054300 Kenmore Washer Parts List

Screw, 8-18 x 1/2 (screw, 10-16 x 3/8)

This screw is sold individually.

Leveling leg locking nut (nut, 3/8-16)

This nut is sold individually. Size: 3/8-16

Lid hinge pad (pad, hinge)

Sold individually.

Spacer (spacer, cabinet to top)

Used to put a space between the cabinet and the top of the washer.

Inlet hose - 5 ft (hose, water inlet (blue coupler))

This hose can handle hot or cold water and is five feet long.

Cabinet retaining clip (clip, top & cabinet & rear panel (2))

CLIP-TOP&CAB-R PNL

Clutch assembly (clutch (complete))

Used with large capacity, automatic washers.

Washer gear case cover seal (seal, gearcase cover)

This part prevents the agitator shaft from leaking oil onto the transmission.

Console clip (clip, console)

Sold individually.

Single motor grommet (grommet, motor (4))

Sold Individually.

Neutral drain kit (neutral assembly)

Oil seal kit for gearcase input shaft (seal, thrust plug)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Water level switch (switch, pressure)

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.