11024054300 Kenmore Washer Parts List

Seal-shaft (seal, oil)

Transmission shaft seal.

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus. 13, 14 & 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Counter balance spring kit (spring, counterweight)

This kit includes 3 springs.

Washer, spin tube thrust

Fits under the basket drive assembly.

Rear leveling foot (foot, rear (2))

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Shaft, agitator (complete) (gear, agitate (includes 15 and 29))

This kit is used for direct drive washing machines and is found inside the gearcase.

Water inlet and dispenser valve (valve, inlet)

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Control panel hinge (hinge, console (2))

Sold individually.

Ring-wire (ring, retaining)

This is part of the Basket Drive and found under the Brake Lining parts.

Cord-power (cord, power (includes item 15))

Water pressure hose - cut-to-fit (hose, airdome to pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support

Used with clutch.