Parts for Kenmore Models 11026942500

Drain hose (hose)

It connects from the pump to the back panel. The clamp is not included.

Easy Part #:: EAP11753688

Availability:: In Stock

Price:: $31.95

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Easy Part #:: EAP11743008

Availability:: In Stock

Price:: $6.64

Pump retainer (retainer, pump)

Sold Individually.

Easy Part #:: EAP11746362

Availability:: In Stock

Price:: $10.22

Tub wear pads - package of 3 (pad-suspen)

This package of pads contains three tub wear pads.

Easy Part #:: EAP334620

Availability:: In Stock

Price:: $15.68

Suspension spring retainer (retainer, suspension spring)

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

Easy Part #:: EAP11749057

Availability:: In Stock

Price:: $6.88

Clutch lining kit (clutch band kit)

This kit comes with springs, hardware, and brake lining.

Easy Part #:: EAP334642

Availability:: In Stock

Price:: $48.51

D-shaped knob insert (spring clip)

This insert is sold individually. Knob not included. Knob is sold separately.

Easy Part #:: EAP11746209

Availability:: In Stock

Price:: $10.33

Water inlet valve and thermistor assembly (valve assembly)

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Easy Part #:: EAP11742194

Availability:: In Stock

Price:: $66.59

Tub-to-pump hose kit (hose)

This kit comes with the clamps.

Easy Part #:: EAP334685

Availability:: In Stock

Price:: $19.37

Cover screw (screw)

Sold individually.

Easy Part #:: EAP11740701

Availability:: In Stock

Price:: $7.40

Drive block - 2 5/16 inch high (block-driv)

This part is for large capacity belt drive and direct drive appliances.

Easy Part #:: EAP11741977

Availability:: In Stock

Price:: $20.53

Washer

This part goes on the agitator retaining bolt.

Easy Part #:: EAP11742027

Availability:: In Stock

Price:: $12.87

Leveling spring

This spring is used on the leveling components in a washer. Please note, this spring may differ in appearance, but functions the same as original.

Easy Part #:: EAP394983

Availability:: In Stock

Price:: $10.37

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.