11026952690 Kenmore Washer Parts List

Washer, spin tube thrust

Fits under the basket drive assembly.

Inner tub filter plug kit (filter, plate)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Lid switch actuator assembly (strike, lid)

This part is used to activate the lid switch when the lid opens/closes.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Rear leveling foot (foot, rear (2))

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Nut-push-in (nut, push-in (2))

Sold individually.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Control panel hinge (hinge, console (2))

Sold individually.

Cord-power (cord, power (power cord only without harness))

Washer outer tub (tub)

This part holds the water during the wash cycle and houses the spin basket.

Water pressure hose - cut-to-fit (hose, pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support

Used with clutch.

Bracket, spring outer (l.F.)

Motor start capacitor (capacitor)

This capacitor gets the motor up to speed before transferring power to the run capacitor.