11026954691 Kenmore Washer Parts List

Washer wire connector (connector)

Hose, sensor (upper) (sensor hose)

Fill hose from mixing valve to sensor housing.

Agitator base assembly (agitator)

Screw, ground (screw)

Water inlet valve - 3 coil (inlet valve)

This washing machine water inlet valve has two ports for water to enter as well as two ports for water to exit. This valve is most typically used with detergent dispensing washers. This water inlet valve attaches the water lines to the back of your washer and the attaching solenoids on the valve open and close according to the desired temperature or amount of water needed.

Siphon break kit

This six piece washing machine syphon break kit for is intended for use with plastic drain hoses. Use this kit with your Whirlpool/Kenmore brand washing machine.

Support

Screw (screw, 10-16 x 5)

Sold individually.

Inner agitator cap seal (seal-cap ring)

Lid hinge - left side (hinge)

Hinge only.

Bumper

Sold individually.

Support, rear panel (support)

3-speed drive motor (complete drive motor assembly)

Motor Specifications: 1725/1140/850 and Amps 9.8/8.5/8.8

Sealer, gasket (.20 fl. Oz.) ( (sealer)

Overlay, graphic (pin, knurled)