11044931302 Kenmore Washer Parts List

Detergent dispenser drawer (drawer, detergent)

This part is the replacement detergent dispenser drawer for your washer. It is made of white plastic and is approximately 11 inches long, 6 inches wide, and 5 inches deep. The detergent dispenser is filled with detergent, which it dispenses during the wash cycle. If a lot of detergent remains in the dispenser after the wash cycle, your clothes aren’t getting clean, or you notice a crack or a break in the dispenser itself, it may need to be replaced. This is an OEM part sourced directly from the manufacturer, and is sold individually.

Baffle set (baffle, tub)

This set includes the 3 baffles ONLY.The screws are sold separately.

Hose clamp (clamp)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Pump hose (hose, tub to pump)

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.

Drain hose (drain hose (inner))

This hose goes from the drain pump to the back of the washer.

Screw (screw, baffle mounting)

Drum drive pulley (pulley)

This drive pulley attaches to the back of the washers drum.

Water level/pressure switch (switch, pressure)

This water level switch senses the level of water in the inner tub.

Spring (spring, suspension)

Sold as a pair.

Shipping bolt kit (bolt, shipping upper)

This kit includes both the upper and lower shipping bolts. 4 in total.

Electronic control board (motor control unit)

This part helps with the tumble and spin cycle. If your motor won't run in either the wash or rinse cycle or if the fuse on the board is blown, then you have to replace this part. The fuse is not sold separately. NOTE: Motor is sold separately.

Gasket, tub

Temperature sensor (ntc)

This part regulates the temperature of the water in the tub. The sensor is located in the heating element.

Outer tub (tub, front)

This part holds the water during the wash cycle and houses the spin basket.

Touch-up paint - biscuit (paint, touch-up (1/2 oz.) bisque)