11047701800 Kenmore Washer Parts List

Drain hose

This hose goes from the drain pump to the back of the washer.

Drum drive pulley (pulley)

This drive pulley attaches to the back of the washers drum.

Dispenser actuator switch (switch-dis)

This is an actuator switch to trigger bleach, detergent, or fabric softener housings to be dispensed into the tub of your washing machine. If your detergent cups are not dispensing, you may need to replace this part. The part is made of off-white plastic and metal.

Inlet hose - 5 ft (inlet hose)

This hose can handle hot or cold water and is five feet long.

Spring

Sold as a pair.

Shipping bolt kit

This kit includes both the upper and lower shipping bolts. 4 in total.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Temperature sensor (sensor-ntc)

This part regulates the temperature of the water in the tub. The sensor is located in the heating element.

Strike

This part attaches to the door and fits into the door lock when the door closes.

Water inlet valve (inlet valve)

This part attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Screw

Nut

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Leveling leg with foot (leveling foot)

Sold individually.

Dispenser seperater (divider)

With Selection Slider.