1106004440 Kenmore Washer Parts List

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Two port water pump (pump assembly)

This 2-port drain pump is used to remove the water from the tub during the drain cycle. This drain pump has been updated by the manufacturer and now replaces all the belt-driven washers with the two hose ports. It may appear different but will function the same as the original pump. If your washer is not draining, you may need to replace the pump. This pump is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Water pressure hose - cut-to-fit (pressure tubing)

This is the hose that tells your appliance if your tub is at the desired water level.

Nut (3/8-16 nut (standard hardware item-may be purchased locally))

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Hose washer kit (filter washer)

Washer fill hose gasket and screen. This is a set of 4.

Lid hinge bumper (bumper)

Screw (no. 10-32 x 5/16 screw (standard hardware item-may be purchased locally))

Sold individually.

Screw, ground (no. 10-24 x 3/8 screw (standard hardware item-may be purchased locally))

Washer (rubber washer (3))

Washer lid hinge (hinge-rear)

Right Side - This lid hinge is for washers. Lid hinge connects the lid to the top panel and allows the lid to pivot open and closed. Wear work gloves to protect your hands when installing this part.

Overlay, graphic (knurled pin)

Belt drive motor kit with capacitor (service motor (production motors 82966, 83131 or 83235))

This two-speed motor performs 1725 revolutions per minute in one speed, and 1140 revolutions per minute in the other speed. It runs at 1/2 horsepower and carries 115 volts.

Screw (no. 8-32 x 1/2 screw (standard hardware item-may be purchased locally))

Sold individually.

Center post bearing (bearing)

Sold individually.

Stopper(4) (stopper)