1106004710 Kenmore Washer Parts List

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Water pressure hose - cut-to-fit (pressure switch hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Nut (3/8-16 nut (standard hardware item - may be purchased locally))

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Lid hinge bumper (bumper)

Screw (no. 10-32 x 5/16 screw)

Sold individually.

Screw (no. 10 x 5/8 screw (standard hardware item - may be purchased locally))

Sold individually.

Washer (rubber washer)

Washer lid hinge (hinge)

Right Side - This lid hinge is for washers. Lid hinge connects the lid to the top panel and allows the lid to pivot open and closed. Wear work gloves to protect your hands when installing this part.

Overlay, graphic (knurled pin)

Belt drive motor kit with capacitor (motor, 60 cycle)

This two-speed motor performs 1725 revolutions per minute in one speed, and 1140 revolutions per minute in the other speed. It runs at 1/2 horsepower and carries 115 volts.

Screw (no. 8-32 x 1/2 screw (standard hardware - may be purchased locally))

Sold individually.

Pump-water (pump assembly (see page 4))

IF FAILED PUMP IS DIE CAST, O

Diverter valve for suds saver (two-way valve assembly)

This valve does not contain the solenoid.

Center post bearing

Sold individually.

Stopper(4) (stopper)