1106004711 Kenmore Washer Parts List

Screw (no. 10-16 x 1/2 screw)

This screw is sold individually.

Water inlet hose washer (rubber washer (2))

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Seal-shaft (oil seal)

Transmission shaft seal.

Hose clamp (clamp)

This clamp helps to prevent leaking by holding the end of water hose in place.

Ring-wire (retainer ring)

This is part of the Basket Drive and found under the Brake Lining parts.

Water pressure hose - cut-to-fit (pressure tubing)

This is the hose that tells your appliance if your tub is at the desired water level.

Nut (3/8-16 nut)

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Hose washer kit (filter washer (2))

Washer fill hose gasket and screen. This is a set of 4.

Lid hinge bumper (bumper)

Screw (no. 10-32 x 5/16 screw)

Sold individually.

Screw, ground (no. 10-24 x 3/8 screw)

Screw (no. 10 x 5/8 screw)

Sold individually.

Washer (rubber washer (4))

Washer lid hinge (hinge-front)

Right Side - This lid hinge is for washers. Lid hinge connects the lid to the top panel and allows the lid to pivot open and closed. Wear work gloves to protect your hands when installing this part.

Overlay, graphic (knurled pin)