11060072990 Kenmore Dryer Parts List

Motor pulley

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Leveling leg locking nut (nut)

This nut is sold individually. Size: 3/8-16

Washer (washer support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Terminal block - block only (terminal block)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Blower housing seal (seal)

This part seals between the blower housing and the blower housing cover.

Spring

Seal, outlet housing (seal)

Screw

This screw is sold individually.

Door handle (handle)

White in color.

Terminal block screw kit (terminal block kit)

This kit includes 3 screws and 3 nuts.

Screw, console

Sold individually.

Clamp-motor (motor clamp)

This clamp is used to secure the drive motor.

Side and bottom vent kit (side exhaust kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Nut-push-in (nut)

Sold individually.

Moisture sensor wire harness (wire harness)