1106114241 Kenmore Washer Parts List

Water inlet hose washer (rubber washer (2))

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Seal-shaft (seal, oil)

Transmission shaft seal.

Water inlet valve (mixing valve-alternate)

This valve has two ports for water to enter. This valve is compatible with a half inch ID hose and it has two 3/4-11x1/2 NHT hose threads.

Hose clamp (clamp)

This clamp helps to prevent leaking by holding the end of water hose in place.

Hex nut (nut and washer (standard hardware item-may be purchased locally))

This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.

Ring-wire (ring, retainer)

This is part of the Basket Drive and found under the Brake Lining parts.

Two port water pump (pump assembly)

This 2-port drain pump is used to remove the water from the tub during the drain cycle. This drain pump has been updated by the manufacturer and now replaces all the belt-driven washers with the two hose ports. It may appear different but will function the same as the original pump. If your washer is not draining, you may need to replace the pump. This pump is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Water pressure hose - cut-to-fit (pressure tubing)

This is the hose that tells your appliance if your tub is at the desired water level.

Screw

Sold individually.

Nut (3/8-16 locknut (standard hardware item-may be purchased locally))

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Hose washer kit (filter washer (2))

Washer fill hose gasket and screen. This is a set of 4.

Wig wag solenoid (wig-wag)

This transmission shifting coil set has 2 solenoids - one turns to start the agitating during the wash cycle and the other turns on to start the spin-dry cycle. Only one solenoid is operating at one time.

Lid hinge bumper (bumper)

Screw (no. 10-32 x 5/16 screw (standard hardware item-may be purchased locally))

Sold individually.

Screw, ground (no. 10-24 x 3/8 screw (standard hardware item-may be purchased locally))