11062182102 Kenmore Dryer Parts List

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Terminal block - block only (block, terminal (2))

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Blower housing seal (seal, cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring, idler)

Seal, outlet housing

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (terminal block screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.

Door switch (door switch assembly)

Side and bottom vent kit (plug, multivent)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Element (heater element)

This element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.

Terminal and wire kit (terminal, brass tinned (3)(includes illus. 18))

Retainer-idler 1/4-20 x 1/16 (retainer, idler)

Sold individually.

Door switch and actuator kit (switch, broken belt)

This part recognizes whether the door is open or closed.

Timer with cams (timer (includes 4-pin cam)(2))

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.