1106804701 Kenmore Washer Parts List

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Water inlet valve (valve, mixing old no. 86829)

This valve has two ports for water to enter. This valve is compatible with a half inch ID hose and it has two 3/4-11x1/2 NHT hose threads.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Two port water pump (pump see parts breakdown)

This 2-port drain pump is used to remove the water from the tub during the drain cycle. This drain pump has been updated by the manufacturer and now replaces all the belt-driven washers with the two hose ports. It may appear different but will function the same as the original pump. If your washer is not draining, you may need to replace the pump. This pump is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Water pressure hose - cut-to-fit (tubing, pressure)

This is the hose that tells your appliance if your tub is at the desired water level.

Screw (bolt)

Sold individually.

Nut

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Screw

This screw is sold individually.

Hose washer kit (washer)

Washer fill hose gasket and screen. This is a set of 4.

Lid hinge bumper (bumper)

Screw

Sold individually.

Screw, ground (screw)

Washer lid hinge (hinge, front)

Right Side - This lid hinge is for washers. Lid hinge connects the lid to the top panel and allows the lid to pivot open and closed. Wear work gloves to protect your hands when installing this part.

Overlay, graphic (pin, knurled)

Terminal (terminal, male)