1107018010 Kenmore Dryer Parts List

Seal

This seal comes with the adhesive backing.

Single front panel cip (clip)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Cover screw (screw, 10-12 x 1/2)

Sold individually.

Drum support roller shaft - right side (shaft-r.H.)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Front top lock (lock, top)

This part is used to secure the top panel to the cabinet. Sold individually.

Rear drum seal with adhesive (seal, rear)

Includes high temperature adhesive.

Single door spring (spring, door-rh)

***The manufacturer suggests to replace both springs at the same time.***

Dryer screw (screw, 11-16)

11-16 x 3/4 Sold individually.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Bearing and seal kit (bearing support)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clip, motor)

This clamp is used to secure the drive motor.

High limit thermostat - l290-40 (thermostat)

With this three-wire high limit/safety thermostat a dryer's heating element will cut out if the internal temperature reaches 290 degrees Fahrenheit. The element will kick back in when the temperature drops to 250 degrees Fahrenheit.

Terminal and wire kit (terminal, tinned)

Seal-door (seal, door)

Adhesive sold separately.

Lint screen hinge - left side (hinge-l.H.)

Sold individually.