1107114030 Kenmore Washer Parts List

Lid switch actuator assembly (lever, switch lid)

This part is used to activate the lid switch when the lid opens/closes.

Water inlet valve (valve, mixing 'service only as a complete valve')

This valve has two ports for water to enter. This valve is compatible with a half inch ID hose and it has two 3/4-11x1/2 NHT hose threads.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Water pressure hose - cut-to-fit (hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Screw (bolt, 5/16-24 x 3/4)

Sold individually.

Nut (nut, 3/8-16 lock)

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Hose washer kit (washer, filter)

Washer fill hose gasket and screen. This is a set of 4.

Screw

Sold individually.

Screw, ground (screw, 10-24 x 3/8)

Screw (screw, 10-12 x 5/8)

Sold individually.

Washer (washer, rubber)

Lid switch shield (shield, lid switch)

Overlay, graphic (pin, knurled)

Terminal (terminal, male)

Belt drive motor kit with capacitor (motor-60 cycle)

This two-speed motor performs 1725 revolutions per minute in one speed, and 1140 revolutions per minute in the other speed. It runs at 1/2 horsepower and carries 115 volts.