1107205610 Kenmore Parts List

Washer (washer support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Inlet hose - 5 ft (hose, inlet)

This hose can handle hot or cold water and is five feet long.

Blower housing seal (seal)

This part seals between the blower housing and the blower housing cover.

Spring

Support roller clip (clip, push-on)

Sold Individually.

Door handle (handle)

White in color.

Seal, outlet housing (seal)

Screw (screw, no. 10-16 x 1/2)

This screw is sold individually.

Water inlet hose washer (washer, rubber)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Screw

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Natural gas orifice for dryer gas valve (orifice)

Touch-up paint - biscuit (tuchup)

Clamp-motor (motor clamp)

This clamp is used to secure the drive motor.

Lid switch actuator assembly (lever, lid switch)

This part is used to activate the lid switch when the lid opens/closes.

Side and bottom vent kit (side exhaust kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.