1107205610 Kenmore Parts List

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Natural gas limiter (limiter)

Moisture sensor wire harness (wire harness)

Water inlet valve (valve, mixing-serviced only as a complete valve)

This valve has two ports for water to enter. This valve is compatible with a half inch ID hose and it has two 3/4-11x1/2 NHT hose threads.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Lens

This parts covers the bulb inside the drum.

Two port water pump (pump assembly)

This 2-port drain pump is used to remove the water from the tub during the drain cycle. This drain pump has been updated by the manufacturer and now replaces all the belt-driven washers with the two hose ports. It may appear different but will function the same as the original pump. If your washer is not draining, you may need to replace the pump. This pump is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Rack-dry (dryer rack)

Water pressure hose - cut-to-fit (hose)

This is the hose that tells your appliance if your tub is at the desired water level.

Door hinge - right side (door hinge)

Right Side

Retainer-idler 1/4-20 x 1/16 (screw)

Sold individually.

Burner tube (shutter)

Includes hood.

Door switch and actuator kit (switch)

This part recognizes whether the door is open or closed.

Clip (clip, compression)

Wiring harness clip.

Door hinge - left side (door hinge)