11076450400 Kenmore Dryer Parts List

Rear drum seal kit (seal, rear)

This seal kit for large capacity gas and electric clothes dryers includes a seal, an adhesive, and an instructions sheet. This felt seal for the back of the drum is sewn with red thread.

Seal (seal, bulkhead to lint chute)

This seal comes with the adhesive backing.

Single front panel cip (clip, hinge)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Drum support roller shaft - right side (shaft, r.H.)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Front top lock (lock, front top)

This part is used to secure the top panel to the cabinet. Sold individually.

Single door spring (spring, door hinge)

***The manufacturer suggests to replace both springs at the same time.***

Dryer screw (screw, 11/16)

11-16 x 3/4 Sold individually.

Support roller clip (clip)

Sold Individually.

Door handle (white)

White in color.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Roller shaft washer (washer)

Bearing and seal kit (asm, seal and bearing)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clip, motor)

This clamp is used to secure the drive motor.

High limit thermostat - l290-40 (thermostat, 290 degrees)

With this three-wire high limit/safety thermostat a dryer's heating element will cut out if the internal temperature reaches 290 degrees Fahrenheit. The element will kick back in when the temperature drops to 250 degrees Fahrenheit.

Toe panel clip kit (clip)