11076904690 Kenmore Dryer Parts List

Dryer drum seal with adhesive (seal, drum)

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

Thermal cut-off fuse kit (thermostat, high-limit 205 deg. F (96 deg. C))

Dryer door switch actuator spring/lever (lever, door switch)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Screw - 10-16 x 1 (screw, 10-16 x 3/4)

This screw is sold individually.

Push-to-start switch - 2 terminal (switch, push-to-start)

This part is used to start the dryer once you have selected a setting on the timer.

Drum support shaft - rear shaft with right hand threads (shaft, l.H. Thread)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Blower wheel (wheel, blower)

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Screw (screw. 8-18 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Single access panel spring retainer/clip (retainer)

Sold Individually.

Cover screw (screw, 10-16 x 1/2)

Sold individually.

Drive motor with threaded shaft - 120v 60hz (motor, assembly 60 hz.)

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Timer (timer, 60 hz.)

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Drum support roller shaft - right hand threads (shaft, r.H. Thread)

This shaft is for the front with right hand thread. Sold individually.

Single access panel clip (clip)

Sold individually.

Motor pulley (pulley 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.