11078002010 Kenmore Dryer Parts List

Lp gas con

This gas conversion kit is used to convert natural gas burners to liquid propane in dryers. If your dryer will not start, heat, or there is an unusual smell, replacing this part can be a solution to the problem. The tools needed for this repair project are: a putty knife, 5/16 inch nut driver, small flathead screwdriver, pliers, and a 3/8 inch wrench. As a safety precaution remember to unplug your dryer from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for further installation instructions and a detailed diagram.

Motor pulley

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Washer (washer support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Console clip

Sold individually.

Blower housing seal (seal)

This part seals between the blower housing and the blower housing cover.

Spring

Seal, outlet housing (seal)

Screw

This screw is sold individually.

Thermal cut-off (cutoff-tml)

The thermal cut off fuse will disrupt the power flow to the drive motor when the dryer gets too hot. If your dryer will not heat properly, or will not heat at all the issue could be with a faulty or damaged thermal cut off fuse. Before you replace the faulty cut off fuse, make sure you disconnect the power from your dryer.

Clamp-motor (motor clamp)

This clamp is used to secure the drive motor.

Side and bottom vent kit (side exhaust kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Natural gas limiter (limiter)

Lens

This parts covers the bulb inside the drum.

Rack-dry (dryer rack)

High limit thermostat - 255f (thermostat)

This part operates the temperature of your unit.