110796228 Kenmore Dryer Parts List

Single front panel cip (clip)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Cover screw (screw)

Sold individually.

Drum support roller shaft - right side (shaft)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Door catch (door latch kit)

This white female door catch is attached to the dryer door.

Motor pulley - 60 hz. (motor pulley)

Sold individually.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Timer (control timer)

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Front top lock (lock)

This part is used to secure the top panel to the cabinet. Sold individually.

Seal-door (door seal)

Push-to-start switch (pts switch)

This part is used to start the dryer once you have selected a setting on the timer.

Leveling leg locking nut (nut)

This nut is sold individually. Size: 3/8-16

Console clip

Sold individually.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Support roller clip (clip)

Sold Individually.

Screw

This screw is sold individually.