11080754001 Kenmore Washer Dryer Combo Parts List

Screw (screw, 10-16 x 1/2 (2) (front panel to side panel))

This screw is sold individually.

Terminal block screw kit (screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Water inlet hose washer (washer, inlet hose (4))

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Seal-shaft (seal, oil)

Transmission shaft seal.

Roller shaft washer (washer, support (4))

Knob spring-clip (spring clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (incls. Illus. 10, 11, and 12))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Heating element - 3000w 240v (element, heater)

This element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.

Bearing and seal kit (bearing and seal)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clamp, motor mounting (2))

This clamp is used to secure the drive motor.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Timer power resistor (resistor assembly)

This part helps your dryer's timer motor work in automatic cycles.