11081061100 Kenmore Washer Parts List

Spin tube bearing (t bearing, spin tube)

This spin tube T-Bearing is an inch long. Sold individually.

Screw, 8-18 x 1/2 (screw 10-16 x 3/8)

This screw is sold individually.

Lid hinge pad (pad, lid hinge)

Sold individually.

Spacer (spacer, cabinet to top)

Used to put a space between the cabinet and the top of the washer.

Spring outer bracket (bracket, spring outer)

Sold individually.

Inlet hose - 5 ft (hose, water inlet)

This hose can handle hot or cold water and is five feet long.

Cabinet retaining clip (clip, top & cabinet & rear panel)

CLIP-TOP&CAB-R PNL

Washer gear case cover seal (seal, gearcase cover)

This part prevents the agitator shaft from leaking oil onto the transmission.

Single motor grommet (grommet, motor)

Sold Individually.

Neutral drain kit (spring, spin gear)

Oil seal kit for gearcase input shaft (plug, thrust)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Capacitor, motor start (capacitor, motor start, mfd 189, 110 volts)

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Water inlet hose washer (washer, water inlet hose, 1-1/16 x 5/8)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Seal-shaft (seal, oil)

Transmission shaft seal.