11081061100 Kenmore Washer Parts List

Centerpost bearing and seal assembly (centerpost bearing kit inclds illus. 13 14 23)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Lid switch actuator assembly (strike, lid)

This part is used to activate the lid switch when the lid opens/closes.

Rear leveling foot (foot, rear)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Switch, main drive motor

Nut-push-in (nut, push-in)

Sold individually.

Control panel hinge (hinge, console)

Sold individually.

Shaft, agitator (complete) (gear, agitator)

This kit is used for direct drive washing machines and is found inside the gearcase.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Ring-wire (ring, retaining)

This is part of the Basket Drive and found under the Brake Lining parts.

Cord-power (cord, power)

Water pressure hose - cut-to-fit (hose pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support

Used with clutch.

Bracket, spring outer (l.F.) (bracket, spring outer, l.F.)

Drum support roller (ring & gasket tub)

This single drum support roller is used for round ported model clothes dryers. The innermost ring, which is the bearing, is made of metal. Though we picture a roller with a white middle, note that this wheel is also available with a black plastic center.