11081361620 Kenmore Washer Parts List

Inner tub filter plug kit (filter plate)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Lid switch actuator assembly (strike lid)

This part is used to activate the lid switch when the lid opens/closes.

Rear leveling foot (foot rear)

Sold Individually. Used to help stabilize the appliance on uneven surfaces.

Switch, main drive motor (switch main drive motor)

Nut-push-in (nut push-in)

Sold individually.

Control panel hinge (hinge console)

Sold individually.

Lid switch actuator (actuator lid switch)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Hose clamp (clamp hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Ring-wire (ring retaining)

This is part of the Basket Drive and found under the Brake Lining parts.

Cord-power (cord power)

Water pressure hose - cut-to-fit (hose pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Ring, spin tube support (ring spin tube support)

Used with clutch.

Bracket, spring outer (l.F.) (bracket spring outer l.F.)

Clip

Wiring harness clip.

Agitator

This part rotates back and forth to move the clothes inside the tub.