11082094130 Kenmore Washer Parts List

Hose clamp (clamp hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Two port water pump (pump assembly)

This 2-port drain pump is used to remove the water from the tub during the drain cycle. This drain pump has been updated by the manufacturer and now replaces all the belt-driven washers with the two hose ports. It may appear different but will function the same as the original pump. If your washer is not draining, you may need to replace the pump. This pump is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Water pressure hose - cut-to-fit (hose suds level switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Clip (clip harness)

Wiring harness clip.

Screw

Sold individually.

Seal (seal agitator shaft)

Nut (locknut 3/8-16)

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Screw

This screw is sold individually.

Screw (screw 8x5/16)

This screw is sold individually.

Hose washer kit (screen filter)

Washer fill hose gasket and screen. This is a set of 4.

Wig wag solenoid (magnet)

This transmission shifting coil set has 2 solenoids - one turns to start the agitating during the wash cycle and the other turns on to start the spin-dry cycle. Only one solenoid is operating at one time.

Lid hinge bumper (bumper lid hinge)

Screw, ground (screw 10-24x3/8)

Leveling leg (foot front)

Screw

Sold individually.