11082094220 Kenmore Washer Parts List

Inlet hose - 5 ft (hose inlet)

This hose can handle hot or cold water and is five feet long.

Support roller clip (clip push-on)

Sold Individually.

O-ring (seal agitator)

Capacitor, motor start (capacitor motor start)

This part gets the motor up to speed quickly before transferring power to the run capacitor.

V-style cogged tooth pump belt (belt v)

Screw (screw 10-16 x 1/2)

This screw is sold individually.

Water inlet hose washer (washer rubber)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Screw (screw 8-18x1/2)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Lid switch actuator assembly (strike lid)

This part is used to activate the lid switch when the lid opens/closes.

Hose clamp (clamp hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Nut-push-in (nut push-in)

Sold individually.

Water inlet valve (valve mixing serviced as complete asm)

This valve has two ports for water to enter. This valve is compatible with a half inch ID hose and it has two 3/4-11x1/2 NHT hose threads.

Hose clamp (clamp hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Two port water pump (pump assembly)

This 2-port drain pump is used to remove the water from the tub during the drain cycle. This drain pump has been updated by the manufacturer and now replaces all the belt-driven washers with the two hose ports. It may appear different but will function the same as the original pump. If your washer is not draining, you may need to replace the pump. This pump is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Water pressure hose - cut-to-fit (hose suds level switch)

This is the hose that tells your appliance if your tub is at the desired water level.