11082370730 Kenmore Washer Parts List

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Ring-wire (ring retainer)

This is part of the Basket Drive and found under the Brake Lining parts.

Two port water pump (pump, complete (suds))

This 2-port drain pump is used to remove the water from the tub during the drain cycle. This drain pump has been updated by the manufacturer and now replaces all the belt-driven washers with the two hose ports. It may appear different but will function the same as the original pump. If your washer is not draining, you may need to replace the pump. This pump is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Water pressure hose - cut-to-fit (hose, pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Clip (clip, harness to top)

Wiring harness clip.

Screw

Sold individually.

Seal (seal, centerpost 357409 (alt.) 359449 (alt.))

Nut (locknut)

This serrated nut is used for many clothes dryers. It is less than an inch long, and is made entirely of metal.

Wig wag solenoid (magnet)

This transmission shifting coil set has 2 solenoids - one turns to start the agitating during the wash cycle and the other turns on to start the spin-dry cycle. Only one solenoid is operating at one time.

Lid hinge bumper (bumper, lid hinge)

Screw, ground (screw)

Leveling leg (foot, front)

Screw

Sold individually.

Inner agitator cap seal (seal, agitator cap)

Wig wag plunger kit (plunger)

This wig wag plunger kit comes with a plunger, a cam bar guide, a rivet, and a speed nut.