11082824101 Kenmore Dryer Parts List

Drum support roller shaft - right hand threads (shaft, r.H. Thread)

This shaft is for the front with right hand thread. Sold individually.

Motor pulley (pulley 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

High limit thermostat - l295-50f (thermostat 295f (146c))

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Dryer screw (screw, 11-16 x 3/4)

11-16 x 3/4 Sold individually.

Leveling leg locking nut (nut, 3/8 x 16 (r.H.))

This nut is sold individually. Size: 3/8-16

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Terminal block - block only (block, terminal)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Blower housing seal (seal, cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring, idler)

Seal, outlet housing

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (terminal block screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Touch-up paint - biscuit (paint, touch-up (1/2 oz.) bisque)

Stacking kit (kit, stack assembly)

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.