11084390410 Kenmore Washer Parts List

Capacitor, motor start

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Lid switch actuator (switch actuator)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Water pressure hose - cut-to-fit (hose, pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Clip (clip, lid switch to top)

Wiring harness clip.

Screw (screw, 10-16 x 1)

This screw is sold individually.

Screw (screw, 8-32 x 1/4)

This screw is sold individually. Size: 8-32 x 1/4 inch.

Seal (seal, centerpost (2))

Hose washer kit (screw, filter (2))

Washer fill hose gasket and screen. This is a set of 4.

Wig wag solenoid (magnet)

This transmission shifting coil set has 2 solenoids - one turns to start the agitating during the wash cycle and the other turns on to start the spin-dry cycle. Only one solenoid is operating at one time.

Lid hinge bumper (bumper, lid hinge (2))

Screw (screw, 10-32 x 5/8)

Sold individually.

Hose, inlet 6 ft. Hose with el (hose, inlet (2))

Requires two washers.