11084416100 Kenmore Washer Parts List

Capacitor, motor start (capacitor motor start)

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw (screw 10-16x1/2)

This screw is sold individually.

Water inlet hose washer (washer 1-1/16x5/8)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Hose clamp (clamp hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Lid switch actuator (switch actuator)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Hose clamp (clamp hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Water pressure hose - cut-to-fit (hose pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.

Clip (clip harness)

Wiring harness clip.

Screw (screw 10-16x1)

This screw is sold individually.

Screw (screw 8-32x1/4)

This screw is sold individually. Size: 8-32 x 1/4 inch.

Seal (seal shaft)

Wig wag solenoid (magnet)

This transmission shifting coil set has 2 solenoids - one turns to start the agitating during the wash cycle and the other turns on to start the spin-dry cycle. Only one solenoid is operating at one time.

Lid hinge bumper (bumper lid hinge)

Screw (screw 10-32x5/8)

Sold individually.

Screw, ground (screu 10x3/8)