11084762300 Kenmore Washer Dryer Combo Parts List

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Inlet hose - 5 ft (hose, inlet (2))

This hose can handle hot or cold water and is five feet long.

Terminal block - block only (block, terminal)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Washer gear case cover seal (seal, gearcase cover)

This part prevents the agitator shaft from leaking oil onto the transmission.

Blower housing seal (seal, transition duct to lint duct)

This part seals between the blower housing and the blower housing cover.

Spring (spring, idler)

Lid switch kit (switch, lid)

The point of the lid switch is for the tub to stop spinning when the washer lid is opened.

Switch, door

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Lint screen - white (screen, lint)

This filter collects lint as it passes through the dryer vent.

Single motor grommet (grommet, motor (4))

Sold Individually.

Neutral drain kit (neutral assembly)

Oil seal kit for gearcase input shaft (seal, thrust plug)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Screw (screw and washer)

Sold individually.

Capacitor, motor start

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Seal, outlet housing