Parts for Kenmore Models 11085088400

Moisture sensor (electrode)

This is the moisture sensor for your dryer. It helps detect the amount of moisture in your clothes during the dryer cycle. If you notice your clothes are still wet after an automatic dryer cycle is done, you may need to replace the sensor. You will find the moisture sensor behind the lint screen. Be sure to disconnect the power source from the dryer before you begin this repair. Note: Some model's require two sensors, please order quantity needed. Sensor only, harness is not included. This part is sold individually.

Easy Part #:: EAP11741408

Availability:: In Stock

Price:: $9.98

Screw, 8/18 x 3/8 (screw 8pk)

This screw is sold individually.

Easy Part #:: EAP11746840

Availability:: In Stock

Price:: $7.40

Dryer drum seal with adhesive (seal)

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

Easy Part #:: EAP970088

Availability:: In Stock

Price:: $42.24

Outlet screen door grille (outlet screen cover)

Top cover for lint filter.

Easy Part #:: EAP12070617

Availability:: In Stock

Price:: $25.88

Screw - 10-16 x 1 (screw)

This screw is sold individually.

Easy Part #:: EAP11741409

Availability:: In Stock

Price:: $7.40

Drum support shaft - rear shaft with right hand threads (shaft)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Easy Part #:: EAP11753708

Availability:: In Stock

Price:: $45.18

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Easy Part #:: EAP11742721

Availability:: In Stock

Price:: $7.37

Blower wheel

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Easy Part #:: EAP11743811

Availability:: In Stock

Price:: $39.66

Cover screw (screw)

Sold individually.

Easy Part #:: EAP11740701

Availability:: In Stock

Price:: $7.40

Drive motor with threaded shaft - 120v 60hz (drive motor assembly)

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Easy Part #:: EAP334287

Availability:: In Stock

Price:: $159.02

Door catch (door latch kit)

This white female door catch is attached to the dryer door.

Easy Part #:: EAP11741434

Availability:: In Stock

Price:: $9.09

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Easy Part #:: EAP347819

Availability:: In Stock

Price:: $18.90

Drum support roller shaft - right hand threads (shaft)

This shaft is for the front with right hand thread. Sold individually.

Easy Part #:: EAP11753707

Availability:: In Stock

Price:: $46.35

High limit thermostat - l295-50f (thermostat)

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Easy Part #:: EAP11741456

Availability:: In Stock

Price:: $73.26

Motor pulley

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.