11086379110 Kenmore Dryer Parts List

Cover screw (screw panel to pedestal)

Sold individually.

Drum support roller shaft - right side (shaft drum support r.H.)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Timer knob (timer knob & clip assembly)

This knob accepts a D-shaped shaft.

Push-to-start switch kit (switch push to start)

This includes the switch, brackets and hardware.

Motor pulley (pulley motor 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Multi rib belt (belt drive)

Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.

Door handle (white)

White in color.

Screw (screw 10-16x1/2)

This screw is sold individually.

Terminal block screw kit (screw kit terminal block)

This kit includes 3 screws and 3 nuts.

Roller shaft washer (washer support)

Knob spring-clip (clip timer knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Bearing and seal kit (bearing & seal)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clamp motor)

This clamp is used to secure the drive motor.

Timer power resistor (resistor & shield assembly)

This part helps your dryer's timer motor work in automatic cycles.

Nut-push-in (nut push in)

Sold individually.