11086379130 Kenmore Dryer Parts List

Screw (screw, 8-18 x 1/2 (2))

Metallic screw that is less than an inch long. Does not include the plastic washer.

Single front panel cip (clip, front panel (2))

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Cover screw (screw, terminal block to cabinet)

Sold individually.

Drum support roller shaft - right side (shaft, drum support (r.H.))

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Timer knob (timer knob & clip assembly)

This knob accepts a D-shaped shaft.

Push-to-start switch kit (switch, push-to-start (345775) (alt.) (348478) (alt.))

This includes the switch, brackets and hardware.

Motor pulley (pulley, motor 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Multi rib belt (belt, drive)

Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.

Door handle (white)

White in color.

Single hex head screw (screw, hex washer head (2))

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw (screw,10-16 x 1/2)

This screw is sold individually.

Roller shaft washer (washer, support (4))

Knob spring-clip (clip, timer knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Bearing and seal kit (bearing & seal)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.