Parts for Kenmore Models 11086747700

Dryer drum seal with adhesive (seal)

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

Easy Part #:: EAP970088

Availability:: In Stock

Price:: $42.24

Outlet screen door grille (outlet screen cover)

Top cover for lint filter.

Easy Part #:: EAP12070617

Availability:: In Stock

Price:: $25.88

Screw - 10-16 x 1 (screw)

This screw is sold individually.

Easy Part #:: EAP11741409

Availability:: In Stock

Price:: $7.40

Drum support shaft - rear shaft with right hand threads (shaft)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Easy Part #:: EAP11753708

Availability:: In Stock

Price:: $45.18

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Easy Part #:: EAP11742721

Availability:: In Stock

Price:: $7.37

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Easy Part #:: EAP11743811

Availability:: In Stock

Price:: $39.66

Cover screw (screw)

Sold individually.

Easy Part #:: EAP11740701

Availability:: In Stock

Price:: $7.40

Drive motor with threaded shaft - 120v 60hz (drive motor assembly)

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Easy Part #:: EAP334287

Availability:: In Stock

Price:: $159.02

Drum support roller shaft - right hand threads (shaft)

This shaft is for the front with right hand thread. Sold individually.

Easy Part #:: EAP11753707

Availability:: In Stock

Price:: $46.35

High limit thermostat (thermostat)

This authentic OEM high limit thermostat is made for your dryer. It is an important dyer element, because it will automatically shut off the heating element when it overheats. Be sure to disconnect the power to your dryer before you begin this repair.

Easy Part #:: EAP11746386

Availability:: In Stock

Price:: $69.53

Door hinge (hinge)

This door hinge is used to hold your door on your dryer in place. Most dryers require two and they are sold individually.

Easy Part #:: EAP11752542

Availability:: In Stock

Price:: $104.68

Motor pulley

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Easy Part #:: EAP11727942

Availability:: In Stock

Price:: $60.63

Dryer screw (screw)

11-16 x 3/4 Sold individually.

Easy Part #:: EAP11748297

Availability:: In Stock

Price:: $7.40

Thermal cut-off with high limit thermostat (cutoff-tml)

The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one time use fuse, so when it does trip, you must replace it. The hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Easy Part #:: EAP991443

Availability:: In Stock

Price:: $42.17

Washer

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.