Parts for Kenmore Models 11086980100

Screw, 8/18 x 3/8 (screw, 8a x 3/8 (2) (end cap to bracket))

This screw is sold individually.

Easy Part #:: EAP11746840

Availability:: In Stock - Ships Today

Price:: $7.40

Dryer door switch actuator spring/lever (clip, door switch)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Easy Part #:: EAP11743767

Availability:: In Stock - Ships Today

Price:: $10.30

Lint trap housing seal (seal, bulkhead to lint chute)

This seal comes with the adhesive backing.

Easy Part #:: EAP11741506

Availability:: In Stock - Ships Today

Price:: $9.09

Two-piece split ring bearing (ring, bearing)

This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during operation, or if there are marks left on your clothes after a cycle, you may need to replace the bearing ring kit. The kit comes with 2 bearings, one for the top and one for the bottom of the dryer drum. Remove the front panel of your dryer to access the dryer drum for this repair. At this point you can use a pair of needle nose pliers to release the old bearing rings from the drum. Snap the new bearing rings on, and reassemble the dryer to complete your repair.

Easy Part #:: EAP334199

Availability:: In Stock - Ships Today

Price:: $48.83

Cycling thermostat - limit 135/155 (thermostat, 150 deg f (65.6 deg c) (341146) (alt.))

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Easy Part #:: EAP11743793

Availability:: In Stock - Ships Today

Price:: $49.43

Drum roller shaft - left side (shaft, l.H.)

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Easy Part #:: EAP11753706

Availability:: In Stock - Ships Today

Price:: $56.71

Rear drum seal kit (seal, rear drum)

This seal kit for large capacity gas and electric clothes dryers includes a seal, an adhesive, and an instructions sheet. This felt seal for the back of the drum is sewn with red thread.

Easy Part #:: EAP334194

Availability:: In Stock - Ships Today

Price:: $59.93

Screw (screw, 8-18 x 1/2 (2))

Metallic screw that is less than an inch long. Does not include the plastic washer.

Easy Part #:: EAP11742721

Availability:: In Stock - Ships Today

Price:: $7.37

Seal and bearing (seal & bearing assembly)

This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Easy Part #:: EAP11773177

Availability:: In Stock - Ships Today

Price:: $43.64

Single front panel cip (clip (2))

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Easy Part #:: EAP11731288

Availability:: In Stock - Ships Today

Price:: $15.32

Cover screw (screw, 10-16 x 1/2)

Sold individually.

Easy Part #:: EAP11740701

Availability:: In Stock - Ships Today

Price:: $7.40

Drum support roller shaft - right side (shaft, r.H.)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.