11086983130 Kenmore Dryer Parts List

Motor pulley (pulley 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Single access panel clip (clip (2))

Sold individually.

Leveling leg locking nut (nut, 3/8 x 16(r.H.))

This nut is sold individually. Size: 3/8-16

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Blower housing seal (seal, cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring, idler)

Single hex head screw (screw, 8-18 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Door handle (white)

White in color.

Seal, outlet housing

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (terminal block screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Light bulb - 120v 25w (lamp, incadescent)

This 120-volt 25-watt light bulb is approximately 2 1/2” long. It has a small, screw-in base twist lock and it is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Screw, console (screw, 8-18 (2))

Sold individually.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.

Knob spring-clip (clip, control knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.